leaps_stnry_cfg_set
Writes configuration of the stationary detection done by the tag node. The configuration can be written even if stationary detection is disabled (see leaps_cfg_tag_set). Writes internal nonvolatile memory so it should be used carefully. New sensitivity setting takes effect immediately if stationary mode is enabled. Default sensitivity is “HIGH”.
Input
sensitivity: ‘0’ | ‘1’ | ‘2’
0 - LOW [512 mg]
1 - NORMAL [2048 mg]
2 - HIGH [4064 mg]
Output
Example
TLV Request |
||
|---|---|---|
Type |
Length |
Value |
0x11 |
0x01 |
0x01 |
Type 0x11 means command leaps_stnry_cfg_set
TLV response |
||
|---|---|---|
Type |
Length |
Value |
0x40 |
0x01 |
0x00 |
Type 0x40 means status code